19PSU
Power Supply 19PSU-350-2DSW
Double Digitally Controlled Precision Linear Power Supply 2× ±350 V / 0.5 A with a Residual Ripple and Noise of ca. 1 ppm
Request
This linear power supply unit can be used to supply our power switches. It contains two independent power supply units that can provide symmetric output voltages. The reference potential, i.e. the potential in the center of the trap, can be defined by an external voltage source. The output current of the power supply unit is electronically limited and its magnitude depends on the output voltage and the heatsink temperature. At the maximum output voltage of ±350 V, an output current of 500 mA minimum can be reached.
The power supply can be remote-controlled by an RS232 interface. The output voltages and current limits can be controlled with a 16-bit precision. Using the RS232 interface, the device state can be monitored and the output voltages and currents can be measured. The device settings are stored in a nonvolatile memory and are restored when the device is powered on again. The device output can be disabled by a digital enable signal connected to the BNC socket on the front panel.
The power supply can be remote-controlled by an RS232 interface. The output voltages and current limits can be controlled with a 16-bit precision. Using the RS232 interface, the device state can be monitored and the output voltages and currents can be measured. The device settings are stored in a nonvolatile memory and are restored when the device is powered on again. The device output can be disabled by a digital enable signal connected to the BNC socket on the front panel.
#Technical Data
Characteristics
- Two independent digitally controlled precision linear power supplies
Input
- Line input: 115/230 V, +10/–15%, connector: IEC inlet C14
- Inrush-current limiter
Output
- Output voltages: 0 – +350 V and 0 – -350 V, respectively
- Voltage and current control by 16-bit digital-to-analog converters
- Maximum output current:
±500 mA at maximum output voltage,
Foldback current limiter reflecting operating temperature and voltage - Short-term stability, ripple and noise: <5 ppm, 1 ppm typ.
- Temperature coefficient of the output voltage: <50 ppm/K, <10 ppm/K typ.
Connectors
- Output and sensing terminals:
8-pin socket Amphenol FLKD-08EGFS-GCP-001 - Enable input: BNC socket
- Optionally: reference potential (output ground): SHV socket
Remote Control
- Interface RS232, connector D-SUB9 female
- Functionality:
Voltage and current control and monitoring, device monitoring - Non-volatile memory for restoring last used configuration
General
- Case: 19" case "Multipac Pro", 3U, 460 mm, rack-mount
- Cooling: liquid cooler on the rear panel, shutdown at excessive temperature
#Additional Information
Components
- PSU-CTRL-2D
- Digital controller module for double power supply units